ML POLYMER®

Short Detail
ML POLYMER is a one part, solvent-free, pure acrylic-based special waterproofing polymer produced by the latest technology. It is ready to use UV resistant, bright, hard elastic and walk able. It is not affected by pedestrian and vehicle traffic and chemicals.

---

 

 

 

 

TECHNICAL PROPERTIES:

•Form: Appearance / Color; Liquid / clear, white or in any color.

•Chemical Base: Acrylic based liquid

•Density: 1.06±0.05 kg/dm3, +20°C

•pH: 6 - 9

•Solids Content: % 52±3, 105°C

•Elongation at Break: Min. % 250 (for 1 mm thickness, at +20°C, after 72 hrs)

•Application Temperature: +5°C- +35°C

•Interval between each application: approx. 4 hours

APPLICATION PROCEDURE:

SUBSTRATE QUALITY / PREPARATION:

•Substrate must be clean, uniform, dry, free of dust, oil or grease and loose or weak particles

•Surface defects and voids should be repaired with TURKQUA FIX repair mortar

•Steel surfaces should be painted with suitable anti-corrosion material before application.

ML POLYMER, diluted to 200%, should be used as a primer on surfaces like eternity, foamed blocks, brick, tile, masonry, concrete and plaster.

APPLICATION CONDITIONS / LIMITATIONS:

•Substrate Temperature min. +5°C, max. +35°C

•Ambient Temperature min. +5°C, max. +35°C

APPLICATION INSTRUCTIONS:

APPLICATION METHOD / TOOLS: Application can be done by brush, roller, or spray gun. First layer should be applied in one direction only and following layer to be perpendicular to the previous one.

WAITING TIME/OVERCOATING: Waiting time depends on the ambient temperature, substrate temperature, relative humidity and the thickness of coating applied. Before applying the second layer, make sure that the first layer is totally cured and dry. Wait 4 hours (at 23°C and %50 relative humidity).

NOTES ON APPLICATION/LIMITATIONS:

•This product is not generally suitable on its own for waterproofing against hydrostatic pressure.

•It is recommended to reinforce the vertical and horizontal joints of excessively cracked surfaces by using geotextile protection layer.

•Freshly applied material should be protected from rain and/or frost for 24 hours.

•ML POLYMER should not be applied during rain, fog and temperatures below +5°C.

CURING DETAILS: ML POLYMER is applied at 23°C:

•Achieves its mechanical strength after three days

•Becomes fully waterproof after almost five days

•Reaches its final strength values after seven days

•At low temperatures, above mentioned durations can be longer all the afore-mentioned times refer to +23°C and 50% relative humidity. Higher temperatures and lower humidity rates quicken, whereas lower temperatures and higher humidity rates slow down the drying process.

CONSUMPTION: For transparent applications on ceramic, tile etc surfaces approx. 150 gr/m2, on concrete, alum and plaster surfaces approx. 500 gr/m2

PACKAGING: 15 kg plastic pails

STORAGE CONDITIONS/SHELF LIFE: 12 months from date of production if stored properly in unopened and undamaged original sealed containers at temperatures between +5°C to +35°C at dry conditions. Protect from excessive temperature and frost.

CLEANING OF TOOLS: Clean all tools and application equipment with clean water immediately after use.

HEALTH AND SAFETY INFORMATION: For information and advice on the safe handling, storage and disposal of chemical products, users shall refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.